If you need a powerful SBC with more functions than the Raspberry Pi conventional, you can look at this Youyeetoo X1 that we present to you. Of course, unlike the Raspberry Pi, which has a large number of gadgets and a good community behind it, in addition to being based on ARM, in this case it is an SBC based on x86, specifically on an 5105th Gen Intel Celeron N11 (Jasper Lake) with four cores and a clock frequency of 2.9 Ghz.
On the other hand, it also has support for various operating systems, such as Ubuntu, which runs it quite well, and even for Windows as well. Therefore, you have a good chance here. To the also have a UEFI AMI BIOS Aptio Like a conventional PC, you can also create a dualboot with two or more operating systems in a simple way, as you would do on a normal PC, and not like other SBCs based on SD cards to load the operating system.
Technical specifications of the Youyeetoo X1
If you want to know the Technical specifications of this new SBC, here I show you everything that this Youyeetoo X1 board can give you:
- Intel Celeeron N5105 quad-core Jasper Lake at 2 Ghz (2.9 Ghz in Turbo mode) + Intel UHD iGPU at 800 Mhz – TDP 10W total
- System memory of 8 or 16 GB RAM type LPDDR4
- Storage:
- Some boards may allow the option to use an eMMC flash with 64, 128 or 256 GB capacity
- It also has a rear M-2 Key-M slot to install an NVMe 2280 SSD
- SATA III port available to install an HDD or SSD with this type of interface
- Video output
- HDMI 2.0 with support up to 4K @ 60 FPS
- Micro HDMI 2.0 up to 4K @ 60 FPS
- MIPI DSI FPC with support for MIPI7LCD touch and with resolution 1024×600 px LCD type
- Audio
- 3.5 mm headphone jack
- Built-in digital microphone with noise reduction function
- 3W amplified 8-ohm speaker integrated on the board
- HDMI audio output
- 2 pins for additional 3.3v analog microphone
- Connectivity:
- RJ45 port for Gigabit Ethernet LAN
- WiFi 5 + Bluetooth 5.0 or WiFi 6 + Bluetooth 5.2 (optional), using modules for the M.2 E-key 2230
- 4G LTE on optional M.2 Key-E 2230 module (you will need a SIM card with data rate to function)
- NFC
- Ports:
- 2x USB 3.0 type A
- 2x USB 2.0 type A
- 2x USB 2.0 via pin header
- 3x UART TTL with connector for RS232, RS485 or CAN Bus
- 4-pin I2C
- 5-pin SPI
- 6-pin with 5x GPIO (I/O at 3.3v)
- Other extras:
- 2x blue and red LEDs on board + 4-pin for extra LEDs
- Power button
- reset button
- BIOS UEFI AMI Aptio Setup (support auto-power on)
- Heatsink and fan included for CPU cooling
- Feeding:
- 12V DC / 3A + DC jack or via 2-pin header
- 6-pin + 4-pin PoE
- Dimensions 115×75 mn
Where to buy
If you are interested in this Youyeetoo X1 SBC, you can get it on Amazon, available in both its version with 8 GB of RAM and also in the version with 16 GB of RAM, depending on your preference:
